Mooney Viscometer

Technical Specification

  • International standards: ISO 289:2018, ASTM D 1646, ASTM D 3346, DIN 53523, BS 903: Part 58, AFNOR T43-00/005, BS 1673, GOST 10722-76, JIS K6300, TGL 25-689, …
  • Test modes: Mooney Viscosity, Mooney Scorch, Stress Relaxation, Mould release, Delta Mooney
  • Rotor: Large (38.10 mm) and Small (30.48 mm) Sealed, with longlife seals
  • Rotor speed: 2.00 turns per minute (0.209 Radians / second)
  • Stress Relaxation: According to ISO 289, DIN 53523 Part 4
  • Temperature control system: Ambient to 232 °C, precision +/- 0.03 °C, digital, microprocessor controlled
  • Units: Mooney – value (MU) | Temperature (°C, °F) | Time (min – min / min – sec / sec)
  • Closing force: 11.5 kN
  • Die configuration Rotor: According to international standards large (ø 38.1 mm) and small (ø 30.48 mm) Rotor
  • Force measurement: In-line torque transducer
  • Rotor shaft seal: Standard or longlife seals available
  • Torque range: 0.01 to 230 MU
  • Sample volume: Two specimens having a combined volume of 25 cm³
  • Temperature check system: Recordings of the temperature gradient on the screen, PID microprocessor monitored
  • Calibration: Fully automatic by built in calibration weights, Software guided
  • Data Interface: Ethernet (10/100 MBit), USB (int.), CF card (int.), RS232 (opt.)
  • Data points: Over 3500 data points available Including: Initial viscosity, ML / ML 1+X, Y+X+Z, Stress Relaxation (loglog), Slope, Intercept, Regressions coefficient, Scorch viscosities and cure times
  • Pneumatics: min. 4.5 Bar / 60 psi
  • Electrical: Single phase 100 – 120 V, 8 Amps or 200 V – 240 V, 5 Amps

 

Scroll to Top